Cisco Catalyst 3560-CX User Manual page 32

On a Desk, Shelf, or Wall (with Mounting Screws)
Step 3
Peel the adhesive strip off the bottom of the screw template.
Step 4 Attach the screw template to the wall.
Step 5 Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the two screw template slots.
Step 6 Insert two screws in the slots on the screw template, and tighten them until they touch the top of the screw template.
Figure 13: Installing the Mounting Screws on the Wall
Catalyst 3560-CX and 2960-CX Switch Hardware Installation Guide
22
Switch Installation