System Preparation; Falling Prevention - Sharp HT-SB35D Operation Manual

System preparation

Make sure to unplug the AC power cord before in-
stalling the sound bar or changing the position.
To mount the sound bar on the wall
Caution:
Be very careful to prevent the sound bar [5.1 lbs.
●
(2.3 kg)] from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not put on
●
the veneer plaster or whitewashed wall. The sound bar
may fall.) If unsure, consult a qualified service techni-
cian.
Mounting screws are not supplied. Use appropriate
●
ones.
Check all wall mount angle screws for looseness.
●
Select a good location. If not, accidents may occur or the
●
sound bar may get damaged.
SHARP is not responsible for accidents resulting
●
from improper installation.
■ Driving screws
SHARP designed the sound bar so you may hang it on the
wall. Use proper screws (not supplied). See below for size
and type.
3/16"
(5 mm)
7/8" (Min. 22 mm)
■ Installing the sound bar
1
Fix the pattern paper to the wall in horizontal posi-
tion as below.
Wall surface

Falling prevention

Safety wires (not supplied) are useful to prevent the
●
sound bar from falling.
1/8" (3.2 mm)
3/8" (9 mm)
21-5/8" (548 mm)
509 mm
44 mm
Pattern paper
(supplied)
2
Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
3/8" (8-9 mm)
3
Fix a wall mount plug into the hole using a hammer,
until it is flush with the wall surface.
3/8" (8-9 mm)
4
Fasten the screws to the wall as shown below. (Total
screw is 2 pieces)
Screw using
Wall surface screwdriver
Wall surface
5
Hang the sound bar onto the screws.
■ When mounting on the wall
Screw eye
(not supplied)
Sound bar
Wall
E-6
1-1/4" (32 mm)
Wall surface
1-1/4" (32 mm)
Wall sur
face
3/16" (4.5 mm - 5 mm)
Gap from wall
surface
Safety wires
(not supplied)
SOUND BAR HOME THEATRE SYSTEM HT-SB35D