System Preparation; Wall Mounting - Sharp HT-SBW460 Operation Manual

System preparation

A
A: Normal Placement (place Sound bar on levelled
surface in front of TV)
B: Wall Mounting

Wall mounting

Make sure to unplug the AC power lead before
installing the sound bar or changing the
position.
Cautions:
● Be very careful to prevent the sound bar [1.5 kg
(3.3 lbs.)] from falling when mounting on the
5.73
wall.
● Before mounting, check the wall strength. (Do
not put on the veneer plaster or whitewashed
wall. The sound bar may fall.) If unsure, consult
a qualified service technician.
● Check all wall mount angle screws for looseness.
● Select a good location. If not, accidents may
occur or the sound bar may get damaged.
● SHARP is not responsible for accidents
resulting from improper installation.
Notes:
● Installation must be carried out by qualified
personnel only. Incorrect assembly can result
in severe personal injury and property damage
(if you intend to install this product yourself, you
must check for installations such as electrical
wiring and plumbing that may be buried inside
the wall). It is the installer's responsibility to
verify that the wall will safely support the total
load of the sound bar and wall brackets.
● Additional tools (not included) are required for
the installation.
● Do not overtightened screws.
● Keep this instruction manual for future reference.
● Use an electronic stud finder to check the wall
type before drilling and mounting.
1.
2.
B
1
2
2.6
3.
4.
E-6
Drill 4 parallel holes (Ø 5.5 mm - 6 mm each
according to wall type) in the wall. The distance
between the holes should be 893 mm. Firmly fix
1 dowel into each hole in the wall if necessary.
If it is a solid brick, first insert the expansion
rubber into the hole. Tighten the wall mount
brackets on the wall with screws and
screwdriver (not included). Make sure that they
are securely installed.
893 mm
893 mm
Ø5.5~6mm
32mm
Remove the screws at the back of the unit.
Install the wall mounting screws into the back
of the unit.
Lift the unit onto the wall mount brackets and
slot into place.
3
Remove the
screws
Install the
wall mounting
screws
4