Sharp HT-SB38 Operation Manual
  1. Manuals
  2. Brands
  3. Sharp Manuals
  4. Home Theater System
  5. HT-SB38
  6. Operation manual

Sharp HT-SB38 Operation Manual

Sound bar home theater system
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
MODEL
HT-SB38
SOUND BAR HOME THEATER SYSTEM
Thank you for purchasing this SHARP product. To obtain the best performance from this product, please
read this manual carefully. It will guide you in operating your SHARP product.
HT-SB38 Sound Bar Home Theater system consisting of HT-SB38 (sound bar system) and CP-SW38 (active
subwoofer system).
Note:
This product is recommended for flat panel TV (LED, LCD and Plasma).
Accessories
The following accessories are included.
Remote Control
(RRMCGA388AW01)
NFC tag x 1
Velcro tape (hook type) x 1
*TINSEA505AWZZZW*|
(GCASP9349AW01)
TINSEA505AWZZ
OPERATION MANUAL
AC/DC adaptor x 2
HDMI Cable x 1
(RADPAA100AWZZ)
(QCNWGA078AWPZ)
Velcro tape (loop type) x 2
(PSHEZA373AW01)
(PSHEZA372AW01)
ENGLISH
AC power cord x 2
)
(TCAUHA034AWZZ)
(QACCDA005AWZZ
Printed in Malaysia
16C R MW 1
Pattern Paper

Advertisement

Table of Contents
loading

Related Manuals for Sharp HT-SB38

Summary of Contents for Sharp HT-SB38

  • Page 1 SOUND BAR HOME THEATER SYSTEM OPERATION MANUAL Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. HT-SB38 Sound Bar Home Theater system consisting of HT-SB38 (sound bar system) and CP-SW38 (active subwoofer system).

  • Page 2: Special Notes

    ® trademarks owned by Bluetooth SIG, Inc. and any use of such marks by SHARP is under license. Other trademarks and trade names are those of their respective owners. The N Mark is a trademark or registered trademark of NFC Forum, Inc.

  • Page 3: Important Safety Instructions

    Important Safety Instructions Additional Safety Information...

  • Page 4: For U.s. Customer Only

    Product, and shall constitute full satisfaction of all claims, whether based on contract, negligence, strict liability or otherwise. In no event shall Sharp be liable, or in any way responsible, for any damages or defects in the Product which were caused by repairs or attempted repairs performed by anyone other than an authorized servicer.

  • Page 5: Volume Control

    SHARP service facility. This unit should only be used within the range of 41°F - 95°F (5°C - 35°C). SHARP is not responsible for damage due to improper use. Refer all servicing to a SHARP authorised 0" (0 cm) service center.

  • Page 6: Controls And Indicators

    Controls and indicators Sound Bar Front Panel 3 4 5 6 1. Left Channel Speakers 7. Sound Mode Button 2. Right Channel Speakers 8. Volume Down / Up Button 3. On/Standby/Input/ Bluetooth Pairing Indicator 9. NFC detection area 4. On/Standby Button 5.

  • Page 7: Connecting The Remote Control

    13. Input Select Button The default TV code for the remote control is TV CODE 14. Mute Button 1. In case SHARP TV is not responding to TV operation 15. Bass/Treble Button button, change the code by selecting TV CODE from the 16.

  • Page 8: Sound Bar Preparation

    ■ Driving screws Screw using Wall surface screwdriver SHARP designed the sound bar so you may hang it on the wall. Use proper screws (not supplied). See below for size and type. 3/16” (4.5 mm - 5 mm) 1/8” (3.2 mm)

  • Page 9: Falling Prevention

    Falling prevention ● Safety wires (not supplied) are useful to prevent the sound bar from falling. ■ When mounting on the wall Screw eye (not supplied) Safety wires (not supplied) Sound bar Wall ■ When placing on the shelf/table Sound bar Screw eye Safety wires (not supplied)

  • Page 10: Placing The System

    Placing the system Installation image: Notes: ● The front panel of the sound bar is not removable. Caution: ● Do not change the installation direction when the sound bar is turned on. ● Do not stand or sit on the sound bar or subwoofer as you may be injured.

  • Page 11: Hdmi Connection

    Press INPUT button repeatedly on the sound bar or remote control until “HDMI 1”, “HDMI 2” or “TV ARC” appears on the display. Notes: the CEC. For SHARP LCD TV, it is named as AQUOS LINK. This sound bar supports HDMI which enables ARC (Audio The system will automatically power off if TV or similar Return Channel).

  • Page 12: Audio Connections To Tvs, Dvd Players, Vcrs, Etc

    Audio connections to TVs, DVD players, VCRs, etc. Other connection (without HDMI) The illustration below shows the flows of audio and video signals. Audio signal DVD/Blu-ray Video signal Disc Player Digital tuner, etc. Notes: Refer to the operation manual of the equipment to be connected. Fully insert the plugs to avoid fuzzy pictures or noises.

  • Page 13: Remote Control

    Remote control Notes: Battery installation The battery indicator will not correctly display the remaining capacity for approximately 10 seconds after Use 2 “AA” size battery (UM/SUM-3, R6, HP-7 or the power has been turned on. similar). The number of bars shown in the battery indicator may Batteries are not included.

  • Page 14: General Control

    Subwoofer “AQUOS speaker is enabled” message will be displayed Control Control if SHARP LCD TV does not detect HT-SB38 during Notes: power on. However the message “AQUOS audio with If a device such as microwave oven, wireless LAN card, AQUOS LINK is enabled” will be displayed soon as HT- Bluetooth device or any other device that uses the SB38 is detected.
  • Page 15 General control (continued) To select a menu on the remote control Bass and Treble Control (remote control) 1. Press MENU button. Bass Control 2. To select a menu, press button, then press 1. Press the BASS/TREBLE button to select bass. button.
  • Page 16 General control (continued) APC (Auto Power Off Control) (remote 3D sound mode control) 3D creates 3D sound through speakers regardless of the type of sound source, whether it is stereo or multichannel. This sound bar can be set to turn off automatically if It simulates sound transmission characteristics using no signal or connection is detected.
  • Page 17 Rear view of the NFC tag NFC tag provided has unique ID for each sound bar. SHARP will not be held liable for the damages caused by rewriting the tags. Keep all small parts away from children as they may be accidentally swallowed.

  • Page 18: Nfc Connection For Audio Playback

    Bluetooth one touch connection via NFC (continued) Playback will start automatically. Otherwise, press NFC connection for audio playback play (on remote control or source device). Check that: Sound will be heard from the speakers of this unit via Your device (smartphone / tablet) has an NFC function. audio streaming.

  • Page 19: Listening To The Sound

    To disconnect the Bluetooth device Select “HT-SB38 SHARP” from the source list. If Perform any of the followings. Passcode* is required, enter “0000”. – Disconnect the Bluetooth connection on the audio source * Passcode may be called PIN Code, Passkey, PIN device.

  • Page 20: Listening To Usb Mass Storage Device/Mp3 Player

    Unplug USB memory device from the USB terminal. ● Notes: SHARP will not be held liable for the loss of data while the USB memory device is connected to the audio system. Files compressed in MP3 and/or WMA format can be played back when connected to the USB terminal.

  • Page 21: Troubleshooting Chart

    Wireless Make sure there is no obstacles If something is wrong with this product, check the following connection cannot (especially metal) blocking before calling your authorized SHARP dealer or service center. be established. between the sound bar and subwoofer. General Manually re-link the sound bar and subwoofer (refer page 13).

  • Page 22: Maintenance

    Troubleshooting chart (continued) Maintenance Condensation Sudden temperature changes, storage or operation in an Cleaning the cabinet extremely humid environment may cause condensation Periodically wipe the cabinet with a soft cloth. inside the cabinet or on the transmitter on the remote Caution: control.

  • Page 23: Specifications

    Specifications As part of our policy of continuous improvement, SHARP USB (MP3 / WMA) reserves the right to make design and specification changes for product improvement without prior notice. USB host Complies with USB 1.1 (Full The performance specification figures indicated are interface Speed)/2.0 Mass Storage Class.

Table of Contents