System Preparation; Installing The Sound Bar - Sharp HT-SB20 Operation Manual

System preparation

To mount the sound bar on the wall
Caution:
Be very careful to prevent the sound bar [5.07 lbs.
●
(2.3 kg)] from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not
●
put on the veneer plaster or whitewashed wall. The
sound bar may fall.) If unsure, consult a qualified
service technician.
Mounting screws are not supplied. Use appropri-
●
ate ones.
Check all wall mount angle screws for looseness.
●
Select a good location. If not, accidents may occur
●
or the sound bar may get damaged.
SHARP is not responsible for accidents result-
●
ing from improper installation.
Driving screws
■
SHARP designed the sound bar so you may hang
it on the wall. Use proper screws (not supplied).
See below for size and type.
1/8" (3.2 mm)
3/16"
(5 mm)
Min. 7/8" (22 mm)

Installing the sound bar

■

Fix the pattern paper to the wall in hori-
zontal position as below.
Wall
509 mm
548 mm
surface
44 mm
3/8" (9 mm)
Pattern paper
(supplied)
E-3
2
Make a hole on the wall following the screw
point marks on the pattern paper by using
a drill.
1-1/4" (32 mm)
3/8" (8-9 mm)
Wall surface
3
Fix a wall mount plug into the hole using
a hammer, until it is flush with the wall
surface.
3/8" (8-9 mm)
Wall surface

Fasten the screws to the wall as shown below.
(Total screw is 2 pieces)
Wall surface
Wall surface

Hang the sound bar onto the screws.
1-1/4" (32 mm)
Screw using
Screwdriver
4.5mm - 5mm
Gap from
wall surface