System Preparation - Sharp HT-SL50 Operation Manual

System preparation

Make sure to unplug the AC power lead before
installing the unit or changing the position.
Select from three installation methods according to the
preferred position.
Using stand
1. Peel off the double sided tape separator and attach the
sound bar stand cushion at the bottom surface of the
sound bar stand.
Sound bar
stand
2. Fix the sound bar stand as shown.
Note:
●
Sound bar stand can be removed by pulling it off
backward from the sound bar.
Sound bar stand cushion
Double
sided
tape
separator
Hook
Option 1
Option 2
Using foot cushions
Option 2
Attach foot cushions as shown
To mount the sound bar on the wall
Caution:
●
Be very careful to prevent the sound bar [1.46 lbs (0.66
kg)] from falling when mounting on the wall.
●
Before mounting, check the wall strength. (Do not put
on the veneer plaster or whitewashed wall. The sound
bar may fall.) If unsure, consult a qualified service
technician.
●
Mounting screws are not supplied. Use appropriate
ones.
●
Check all wall mount angle screws for looseness.
●
Select a good location. If not, accidents may occur or
the sound bar may get damaged.
●
SHARP is not responsible for accidents resulting
from improper installation.
●
Do not let children dangle on the sound bar once it is
attached on the wall as it can cause damage and injury.
Driving screws
SHARP designed the sound bar so you may hang them on
the wall. Use proper screws (not supplied). See below for
size and type.
3/16"
(5 mm)
7/8" (Min. 22 mm)
E-7
Option 1
Option 2
Option 1
1/8" (3.2 mm)
3/8" (9 mm)