Table of Contents
Advertisement
The Freedom™ Strip Hex-4 offers wireless control of 2 or more products with a single DMX
D-Fi™ 2.4 GHz
controller. To automatically set up D-Fi™ 2.4 GHz syncing for DMX, do the following:
(DMX Mode
For the receiving product(s):
Auto Sync)
1.
2.
3.
4.
5.
For the transmitting product:
1.
2.
3.
4.
5.
Receiving products must be set up before the transmitting product. Once the steps above
are done, press and hold <AUTO> on just the transmitter for approximately 30 seconds.
The display and signal LED will flash to indicate sync is activated.
You can then back out to a general menu level and configure the transmitting product to
operate it with a DMX controller.
To configure your product to work with DMX, refer to the Starting Address section.
·
·
·
·
·
Caution: D-Fi™ 2.4 GHz operation can be interrupted or inhibited by liquid masses
between the transmitter and receiver such as water, snow, or people. For best results,
keep the line of sight clear of any liquid mass.
Page 14 of 25
Press <MENU> repeatedly until S-tr shows on the display.
Press <ENTER>.
Press <UP> or <DOWN> until drAS appears on the display.
Press <ENTER>.
The display should show drAU.
Press <MENU> repeatedly until S-tr shows on the display.
Press <ENTER>.
Press <UP> or <DOWN> until dtAS appears on the display.
Press <ENTER>.
The display should show dtAU.
To add additional Freedom™ products, turn the synced ones off and repeat the
above steps with un-synced products. Once all products are synced, turn them all
back on.
Auto scan syncing must be done within a distance of about 32 ft (10 m).
Manual syncing is recommended for best results when adding products after
initial system setup.
If you are experiencing issues or need to improve signal quality, keep the line of
sight between products unobstructed.
Ensure that all linked products are configured to the same DMX personality.
Freedom™ Strip Hex-4 User Manual Rev. 1
Advertisement
Table of Contents
