The Freedom™ Strip Hex-4 operates in Master/Slave mode, or in DMX mode, both of
DMX
which require DMX linking. In Master/Slave mode the master product sends DMX signals
to the slaves. In DMX mode the lighting control board sends DMX signals to the products.
To DMX-link a number of Freedom™ Strip Hex-4 using DMX cable, see
The Freedom™ Strip Hex-4 offers wireless control of 2 or more products with a single DMX
D-Fi™ 2.4 GHz
controller. To manually set up the D-Fi™ 2.4 GHz syncing for DMX, do the following.
(DMX Mode
For the transmitting product:
Manual Sync)
1.
2.
3.
4.
5.
For the receiving product(s):
1.
2.
3.
4.
5.
To sync multiple transmitters in one room, manually set each receiver and the
designated transmitter to a specific frequency and then perform the syncing steps.
Freedom™ Strip Hex-4 is fully compatible with the D-Fi™ 2.4 GHz wireless
transceiver (transmitter/receiver) from Chauvet (sold separately).
For more detailed information about D-Fi™ 2.4 GHz functionality, refer to the D-Fi™
2.4 GHz User Manual available at the Chauvet website
Manual syncing is recommended for best results.
Freedom™ Strip Hex-4 User Manual Rev. 1
Press <MENU> repeatedly until S-tr shows on the display.
Press <ENTER>.
Press <UP> or <DOWN> until dtCH appears on the display.
Press <ENTER>.
Use <UP> or <DOWN> to select the transmitting signal (dt 1–dt16).
Press <MENU> repeatedly until S-tr shows on the display.
Press <ENTER>.
Press <UP> or <DOWN> until drCH appears on the display.
Press <ENTER>.
Use <UP> or <DOWN> to select the receiving signal (dr 1–dr16). The channel number
should match the transmitting signal you chose when setting up the transmitting product.
DMX
Linking.
www.chauvetlighting.com.
Page 13 of 25