D-Fi™ 2.4 Ghz (Dmx Mode Auto Sync) - Chauvet Freedom Par Tri-6 User Manual

D-Fi™ 2.4 GHz
(DMX Mode
Auto Sync)
Linking
Products
Freedom™ Par Tri-6 User Manual Rev. 1
The Freedom™ Par Tri-6 offers wireless control of 2 or more products with a single DMX controller. To
automatically set up D-Fi™ 2.4 GHz syncing for DMX, do the following:
For the receiving product(s):
1. Press <MENU> repeatedly until S-tr shows on the display.
2. Press <ENTER>.
3. Press <UP> or <DOWN> until drAS appears on the display.
4. Press <ENTER>.
5. The display should show drAU.
For the transmitting product:
1. Press <MENU> repeatedly until S-tr shows on the display.
2. Press <ENTER>.
3. Press <UP> or <DOWN> until dtAS appears on the display.
4. Press <ENTER>.
5. The display should show dtAU.
Receiving units must be set up before the transmitting unit. Once the steps above are done, press and
hold <AUTO> on just the transmitter for approximately 30 seconds. The display and signal LED will flash
to indicate sync is activated.
You can then back out to a general menu level and configure the transmitting product to operate it with a
DMX controller.
To configure your product to work with DMX, refer to the
·
To add additional Freedom™ products, turn the synced ones off and repeat the above steps
with unsynced products. Once all products are synced, turn them all back on.
·
Auto scan syncing must be done within a distance of about 32 ft (10 m).
·
Manual syncing is recommended for best results when adding products after initial system
setup.
·
If you are experiencing issues or need to improve signal quality, keep the line of sight
between products unobstructed.
·
Ensure that all linked products are configured to the same DMX personality.
Caution: D-Fi™ 2.4 GHz operation can be interrupted or inhibited by liquid masses between the
transmitter and receiver such as water, snow, or people. For best results, keep the line of sight
clear of any liquid mass.
DMX Controller Board
Freedom™ Par sends wireless
DMX signal to DMX-
compatible products
wirelessly or via DMX cable
Starting Address
Wireless D-Fi™ Hub
section.
DMX-compatible
Brand X product
To more DMX
compatible
products
DMX-compatible
Brand X product
Page 13 of 22