Table of Contents
Advertisement
Configuration
(Standalone)
Static Color Mode
Auto Program
Mode
Program Speed
Sound-Active
Mode
Sound Sensitivity
Custom Color
Mixing Mode
SlimBEAM™ QUAD IRC User Manual Rev. 1
Set the product in one of the standalone modes to control without a DMX controller.
·
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX signals
that could interfere with the DMX signals from the controller.
To run the SlimBEAM™ QUAD IRC in static-color mode, follow the instructions below:
1.
Press <MENU> repeatedly until C-- shows on the display.
2.
Press <ENTER> and C 1–C15 will show on the display.
3.
Use <UP> or <DOWN> to select the desired color.
4.
Press <ENTER>.
To run the SlimBEAM™ QUAD IRC in automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER> and P 1–P 10 will show on the display.
3.
Use <UP> or <DOWN> to select the desired program.
4.
Press <ENTER>.
To adjust the auto program speed, follow the instructions below:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Press <UP> or <DOWN> and S 1–S100 will show on the display.
3.
Use <UP> or <DOWN> to increase or decrease the program speed.
4.
Press <ENTER> at the desired speed to set it and return to Auto Program mode.
To run the SlimBEAM™ QUAD IRC in sound-active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To adjust the sound sensitivity, follow the instructions below:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Press <UP> or <DOWN> and u 0–u100 will show on the display.
3.
Use <UP> or <DOWN> to increase or decrease the sound sensitivity.
4.
Press <ENTER> when the product responds to the beat of the music to set the
sensitivity and return to Sound-Active mode.
To custom mix a color, follow the instructions below:
1.
Press <MENU> repeatedly until U-- shows on the display.
2.
Press <ENTER> and one of the following will show on the display:
·
rxxx (red, 0-255)
·
gxxx (green, 0-255)
·
bxxx (blue, 0-255)
·
Axxx (amber, 0-255)
3.
Press <ENTER> to cycle through the color settings
4.
Use <UP> or <DOWN> to increase or decrease the selected color value.
NOTE: Selecting 0 will turn the color off.
5.
Repeat steps 3 and 4 until you have your desired color.
Page 13 of 19
Advertisement
Table of Contents
