Decorative Fronts - Heat & Glo 6000CL-IPI-S Owner's Manual

C. Decorative Fronts
Only decorative fronts certifi ed for use with this appliance
model may be used. Contact your dealer for a list of dec-
orative fronts that may be used. Once you have deter-
mined what kind of decorative front and fi nishing material
is going to be used on the fi replace, you may use the
table below which shows the decorative front models and
the fi nishing material thickness allowed.
DECORATIVE
FIT
FRONT
Folio Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
Chateau
Forge
Inside
Overlap
Galleria
Inside
CF Inside
Note: Finishing strips may be used to aid in positioning of
non-combustible facing materials for some of the facing and
decorative front combinations specifi ed in the table above.
They must be removed following fi nishing work. See fi gure
13.7.
Heat & Glo • 6000CL-IPI-S, 6000CL-IPI-T, 8000CL-IPI-S 8000CL-IPI-T • 2165-900 Rev. AB • 3/15
54
FINISH MATERIAL SEE
THICKNESS FIGURE
Any 13.6
1 inch or less 13.4
Greater than 1 inch 13.5
1 inch or less 13.4
Greater than 1 inch 13.5
1 inch or less 13.4
Greater than 1 inch 13.5
1 inch or less 13.4
Greater than 1 inch 13.5
1 inch or less 13.4
Greater than 1 inch 13.5
Any 13.6
Finishing Material:
1 Inch Thick or Less
Remove Finishing Strips. See Figure 13.7.
NOTICE: Remove fi nishing strips before fi ring appliance.
DOOR
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
Figure 13.4 Finishing Material 1 Inch Thick or Less
1 in. MAX.
FINISHING MATERIAL
(TOP EDGE)
FINISHING STRIP NOT USED
(See Figure 13.7 for
removal instructions)
NON-COMBUSTIBLE
FINISHING MATERIAL