Electrical Information; Wiring Requirements; Intellifire Tm Plus Ignition System Wiring - Heat & Glo 6000CL-IPI-S Owner's Manual

12 12

Electrical Information

A. Wiring Requirements
NOTICE: This appliance must be electrically wired
and grounded in accordance with local codes or, in the
absence of local codes, with National Electric Code
ANSI/NFPA 70-latest edition or the Canadian Electric
Code CSA C22.1.
• Wire the appliance junction box to 110-120 VAC. This is
required for use of optional accessories (standing pilot
ignition) or proper operation of the appliance (IntelliFire
Plus ignition).
• A 110-120 VAC circuit for this product must be protected
with ground-fault circuit-interrupter protection, in
compliance with the applicable electrical codes, when
it is installed in locations such as in bathrooms or near
sinks.
TO JUNCTION
BOX (110V)
FLAME
MODULATION
ORANGE GREEN
(PILOT) (MAIN)
BATTERY PACK
6V DC
Figure 12.1 IPI Wiring Diagram
Heat & Glo • 6000CL-IPI-S, 6000CL-IPI-T, 8000CL-IPI-S 8000CL-IPI-T • 2165-900 Rev. AB • 3/15
FLAME
SENSE
MODULE
I
S
RED
BLACK
BROWN
GROUND
NOT USED FOR 6000CL-IPI OR
8000CL-IPI MODELS.
• Low voltage and 110-120 VAC voltage cannot be shared
within the same wall box.
WARNING! Risk of Shock or Explosion! DO NOT wire
110V to the valve or to the appliance wall switch. Incorrect
wiring will damage controls.
B. IntelliFire
• Wire the appliance junction box to 110-120 VAC for
proper operation of the appliance.
TM
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction box to a switched circuit.
Incorrect wiring will override IPI safety lockout.
• Refer to Figure 12.1, IPI Wiring Diagram.
• This appliance is equipped with an IntelliFire
control valve which operates on a 6 volt system.
• Plug the 6 volt transformer plug into the appliance junction
box to supply power to the unit OR install 4 AA cell
batteries (not included) into the battery pack before use.
IGNITER
3 PRONG 110VAC
GROUND
AUX300 MODULE
FAN
AUX 2
AUX 1
LED CONTROL
Plus Ignition System Wiring
TM
RC300 4.5V DC
(AAA X 3)
AUX2 NOT USED FOR 6000/8000 MODELS.
PROTECTIVE COVER INCLUDED
TO JUNCTION
BOX 110VAC
REAR ACCENT LIGHTING (X 2)
Plus
TM
51