Garmin Edge 810 Quick Start Manual page 4

Installing the Out-Front Mount
1
Select a secure location to mount the
Edge where it does not interfere with
the safe operation of your bike.
2
Use the hex key to remove the screw
CD
from the handlebar connector
<2) .
3
If you want to change the orientation
of the mount, remove the two screws
on the back side of the mount @,
rotate the connector @, and replace
the screws.
4
If the handlebar diameter is 26 mm,
place the rubber pad around the
handlebar.
5
Place the handlebar connector around
the rubber pad or handlebar (31.8 mm
diameter).
6
Replace the screw.
4
NOTE: Garmin® recommends a
torque specification of 7 lbf-in. (0.8 N-
m). Check the tightness of the screw
periodically.
7
Align the tabs on the back of the Edge
with the bike mount notches @.
8
Press down slightly and turn the Edge
clockwise until it locks into place.
Releasing the Edge
1
Turn the Edge clockwise to unlock the
device.
2
Lift the Edge off the mount.
Turning On the Device
The first time you turn on the device, you
are prompted to configure system settings
and profiles (page 13).
1
Hold
6 .