Garmin Edge 810 Quick Start Manual page 11

optional sensors, go to
http://buy.garmin.com.
Putting On the Heart Rate Monitor
NOTE: If you do not have a heart rate
monitor, you can skip this task.
You should wear the heart rate monitor
directly on your skin, just below your
breastplate. It should be snug enough to
stay in place during your activity.
1
Snap the heart rate monitor module
CD
onto the strap.
2
Wet both electrodes
@
on the back of
the strap to create a strong connection
between your chest and the
transmitter.
3
If the heart rate monitor has a contact
patch @, wet the contact patch.
4
Wrap the strap around your chest, and
connect the strap hook @ to the loop.
The Garmin logo should be right-side
up.
5
Bring the device within range (3 m) of
the heart rate monitor.
After you put on the heart rate monitor, it
is on standby and ready to send data.
TIP: If the heart rate data is erratic or
does not appear, you may have to tighten
the strap on your chest or warm up for 5-
10 minutes.
Installing the GSC 10
NOTE: If you do not have a GSC
10, you
can skip this task.
Both magnets must be aligned with their
respective indication lines for the Edge to
receive data.
1
Place the GSC 1 0 on the rear chain
stay (on the side opposite the drive
train).
2
If necessary, place the flat rubber pad
CD
or the triangle-shaped rubber pad
between the GSC 1 0 and the chain
stay for stability.
11