Device Information; Specifications; Edge Specifications; Heart Rate Monitor Specifications - Garmin Edge 810 Quick Start Manual

Device Information

Specifications

Edge Specifications

Battery type 1100 mAh rechargable, built-in lithium-ion
battery
Battery life 15 hours, typical usage
Optional external 20 hours, typical usage
battery (accessory)
Water resistance IPX7
Operating temperature From -4º to 140ºF (from -20º to 60ºC)
range
Charging temperature From 32º to 113ºF (from 0º to 45ºC )
range
Bands (O-rings) for the Two sizes:
standard mount
• 1.3 × 1.5 × 0.9 in. AS568-125
• 1.7 × 1.9 × 0.9 in. AS568-131
NOTE: Use Ethylene Propylene Diene
Monomer (EPDM) replacement bands only.
Go to http://buy.garmin.com, or contact your
Garmin dealer.
About IPX7
The device is waterproof to IEC Standard 60529 IPX7. It can
withstand immersion in 1 meter of water for 30 minutes.
Prolonged submersion can cause damage to the device. After
submersion, be certain to wipe dry and air dry the device before
using or charging.

Heart Rate Monitor Specifications

Battery type User-replaceable CR2032, 3 volts
Battery life Up to 4.5 years (1 hour per day). When the
battery is low, a message appears on your
compatible Garmin device.
Water resistance Water resistant to 98.4 ft. (30 m)
NOTE: This product does not transmit heart rate
data to your GPS device while swimming.
Operating From 23° to 122°F (from -5° to 50°C)
temperature range
Radio frequency/ 2.4 GHz ANT+ wireless communications protocol
protocol

GSC 10 Specifications

Battery type User-replaceable CR2032, 3 volts
Battery life Approximately 1.4 years (1 hour per day)
Water resistance IPX7
Operating temperature From 5º to 158ºF (from -15º to 70ºC)
range
Radio frequency/protocol 2.4 GHz ANT+ wireless communications
protocol

Device Care

Do not store the device where prolonged exposure to extreme
temperatures can occur, because it can cause permanent
damage.
Never use a hard or sharp object to operate the touch screen,
or damage may result.
Avoid chemical cleaners and solvents that can damage plastic
components.
Secure the weather cap tightly to prevent damage to the mini-
USB port.
Device Information
NOTICE
NOTICE

Cleaning the Device

1 Wipe the device with a cloth dampened with a mild detergent
solution.
2
Wipe it dry.

Caring for the Heart Rate Monitor

You must unsnap the module before cleaning the strap.
A build up of sweat and salt on the strap can decrease the
ability of the heart rate monitor to report accurate data.
• Go to www.garmin.com/HRMcare
instructions.
• Rinse the strap after every use.
• Machine wash the strap after every seven uses.
• Do not put the strap in a dryer.
• To prolong the life of your heart rate monitor, unsnap the
module when not in use.

Heart Rate Monitor Battery

Do not use a sharp object to remove user-replaceable batteries.
Contact your local waste disposal department to properly
recycle the batteries. Perchlorate Material – special handling
may apply. Go to www.dtsc.ca.gov/hazardouswaste
/perchlorate.

Replacing the Heart Rate Monitor Battery

1
Use a small Phillips screwdriver to remove the four screws
on the back of the module.
2
Remove the cover and battery.
3 Wait 30 seconds.
4
Insert the new battery with the positive side facing up.
NOTE: Do not damage or lose the O-ring gasket.
5
Replace the back cover and the four screws.
After you replace the heart rate monitor battery, you must pair it
with the device again.

Replacing the GSC 10 Battery

1
Locate the circular battery cover
10.
NOTICE
for detailed washing
WARNING
on the side of the GSC
13