Emptying The Condensed Water Container; Cleaning The Evaporator Filter And Evaporator - Asko T754HP Operating Instructions Manual

Care and cleaning
Emptying the condensed water
container
If you have not connected the machine to a
separate drain the condensed water container
must be emptied after each load. Remove the
condensed water container, empty out the water
and replace the container.
If the condensed water container becomes too
full, the program is interrupted and F10 is shown
in the display. Empty the container and press
the Start button to restart the program.
For connection to a separate drain, see the
installation instructions in the set of documents.
NOTE!
The dryer must not be used without the
condenser unit in place.
Cleaning the evaporator filter and
evaporator
The evaporator filter (A+B) should be cleaned
after every 10 uses of the machine and the
evaporator (C) when necessary.
1. Turn off the Main power switch and open the
outer door.
2. Remove the plinth.
3. Open the evaporator door.
4. Pull out the filter by grasping the "handle" in
the middle.
15