Care And Cleaning; Cleaning The Lint Filter; Emptying The Condensed Water Container; Cleaning The Outside Of The Machine - Asko T793 Operating Instructions Manual

Care and cleaning

Cleaning the lint filter

The lint filter must be cleaned after each load.
If you have very hard water, this can cause
limescale deposits in the lint filter. Check for
any limescale deposits when cleaning the lint
filter and, if necessary, wash the filter by hand.
1. Grasp the filter handle and pull it towards
you.
2. Pull the filter out of its holder.
3. Open the filter and remove the lint from all
sides of it by hand. Use a soft, dry cloth to
remove any deposits.
4. Replace the filter in its holder.
Note!
If you have hard water, the filter should be
washed with water to get rid of any limescale
deposits. Dry the filter carefully with a towel.
If you cannot remove the limescale, you can
buy a new filter from the retailer where you
bought the tumble dryer.
Emptying the condensed water
container
The condensed water container must be
drained after each load. Remove the
condensed water container, empty out the
water and replace the container. If the
condensed water container becomes too full,
the program is interrupted and "Over Flow
fault" appears on the display. Empty the
container and press the Start button to restart
the program. See also the "Troubleshooting"
chapter.
Note!
Do not remove the condensed water
container while the machine is running.

Cleaning the outside of the machine

Clean the outside of the machine and the
program panel with a mild cleaner. Do not use
solvents, as these can damage the machine.
Do not hose down or spray the machine with
water.
Note!
Do not allow dust to accumulate around the
machine. Keep the area around the tumble
dryer clean and cool; dust, heat and moisture
prolong drying times.
19