Samsung MultiXpress M537x series Basic Manual page 259

Solving other problems
31
Scanning problems
Condition
The scanner does not work.
Suggested solutions
• Make sure that you place the original to be
scanned face down on the scanner glass, or
face up in the DSDF.
• There may not be enough available memory
to hold the document you want to scan. Try
the Prescan function to see if that works. Try
lowering the scan resolution rate.
• Check that the machine cable is connected
properly.
• Make sure that the machine cable is not
defective. Switch the cable with a known
good cable. If necessary, replace the cable.
• Check that the scanner is configured
correctly.
Condition
The unit scans very slowly. • Check if the machine is printing received
• Graphics are scanned more slowly than text.
• Communication speed slows in scan mode
Message appears on your • There may be a copying or printing job in
computer screen:
• Device can't be set to the
• The selected port is currently being used.
H/W mode you want.
• Port is being used by
• The machine cable may be improperly
another program.
• Port is Disabled.
• The scanner driver is not installed or the
• Scanner is busy receiving
or printing data. When the
current job is completed,
• Ensure that the machine is properly
try again.
• Invalid handle.
• Scanning has failed.
• The USB cable may be improperly connected
Suggested solutions
data. If so, scan the document after the
received data has been printed.
because of the large amount of memory
required to analyze and reproduce the
scanned image. Set your computer to the
ECP printer mode through BIOS setting. It
will help to increase the speed. For details
about how to set BIOS, refer to your
computer user's guide.
progress. Try your job again when that job is
finished.
Restart your computer and try again.
connected or the power may be off.
operating environment is not set up
properly.
connected and the power is on, then restart
your computer.
or the power may be off.
9. Troubleshooting
259