Jumper And Switch Settings - Daikin 3MKS50E3V1B Service Manual

Field Settings
Wireless Remote (1) Remove the cover and take it off.
Controller (2) Cut the address setting jumper.
ARC466 series
ARC433 series

5.2.3 Jumper and Switch Settings

<Floor Standing Type: FVXS Series>
Switch (on indoor unit
<Floor / Ceiling Suspended Dual Type>
Switch (on indoor unit
For the location of the jumper and the switch, refer to the following pages.
418
Jumper
ADDRESS
EXIST 1
CUT
2
ADDRESS
EXIST 1
CUT 2
Jumper (on indoor
unit PCB)
JB Fan speed setting
when compressor
stops for thermostat
OFF. (effective only
at cooling operation)
JC Power failure
recovery function
PCB)
SW2-4 Upward airflow limit
setting
PCB)
SW2 Installation style
changeover
Wall Mounted Type: page 42, 45, 47, 50
Floor Standing Type: page 53, 56
Floor / Ceiling Suspended Dual Type: page 58
Duct Connected Type: page 60
ARC452 series
ADDRESS
EXIST
CUT
(R12037)
Jumper
(R6573)
Function When connected
(factory set)
Fan speed setting ;
Remote controller
setting
Auto-restart
Function OFF (factory set)
Exposed or half
embedded
installation
Function FLOOR (factory
set)
When installed as
the floor mounted
type
SiBE121135
Jumper
1
2
(R12065)
When cut
Fan speed setting; "0" (The fan
stops.)
The unit does not resume
operation after recovering from a
power failure. Timer settings are
cleared.
ON
Set the switch to ON position
when you install the indoor unit
embedded in the wall to avoid
condensation.
CEILING
When installed as the ceiling
suspended type
Trial Operation and Field Settings