Key Programming; Programming (General) - Mitel 600 Series User Manual

Mitel 600 Series DECT Phone User Guide

KEY PROGRAMMING

Your DECT phone supports the assignment of frequently used functions to specific keys.
Mitel 610d, 612d
You can program the left and middle softkeys below the display, and the left and right navigation
keys. The programmed left and right navigation keys can also be used in the handset's call
connection state (providing their programming differs from the factory setting with the settings of
Info and Profile).
Mitel 620d / 622d / 630d / 632d / 650c
You can program the left and middle softkey below the display. These programmed keys can
only be used in the idle state.
The three sidekeys (left) and the hotkey (right) can be programmed as before. These programmed
keys can be used in the handset's idle state and call connection state.
A programmed left or right navigation key can also be used in the handset's call connection state,
but only if their programming differs from the factory setting with the setting Info and Profile.
After you have programmed the keys, the icon for the programmed function is indicated on the
display (does not apply to the Hotkey). You can access the function with a short key-press.
Note: Some functions can only be displayed in the connected state. For instance, if you
call up the call list, you can browse through it and edit it, but you cannot dial a call number
directly from the list.

PROGRAMMING (GENERAL)

Press and hold the appropriate key or use the Menu >>> -> Settings -> Key programming (see
"Settings menu" on page
If you press the
Press Ok.
The following selection is available
No function
VIP list
Alarm clock
Appointment
Profile
Info
68
58).
softkey during key programming, you get the default key of the factory setting.
Key is not assigned.
Key is assigned with a list of phone numbers (maximum 6
entries).
You can program entries to the alarm clock settings.
You can program entries to the appointment settings.
The selection of profiles is offered.
The Info menu (caller list, redial list, etc.) can be programmed.