Installation; Inserting The Standard Battery; Installing/Removing A Mounting Bracket Or Rotary Clip - Mitel 600 Series User Manual

INSTALLATION

INSERTING THE STANDARD BATTERY

Mitel 610d, 612d, 620d, 622d, 650c
1. Push the battery cover downwards until it disengages
from the locking mechanism and lift off.
2. Insert the battery with the contacts downwards.
3. Replace the battery cover and push upwards until it
snaps into place.
Mitel 630d, 632d
1. Undo the two screws on the back of the handset with
a suitable tool and remove the cover.
2. Insert the battery with the contacts downwards.
3. Close the battery compartment with the cover (insert
underneath, press down from above) and screw back
in place. Do not damage the rubber seal when
assembling.

INSTALLING/REMOVING A MOUNTING BRACKET OR ROTARY CLIP

Mitel 610d, 612d, 620d, 622d, 650c
1. Place the supplied fixing bracket on both openings at
the upper end of the DECT phone and snap in place
by pressing downwards.
2. To remove the fixing bracket, press into the small
cutouts at the edge of the bracket and pull the two
sides slightly apart.
The devices can also be fitted with a rotary clip as an
accessory.
Mitel 610d, 612d, 620d, 622d, 650c
1. Place the supplied fixing bracket on both openings at
the upper end of the DECT phone and snap in place
by pressing downwards. The clip is then pushed onto
the protruding button.
2. To release the handset from the clip, press the top
button.
Mitel 630d, 632d
Remove the fixing bracket and replace it with the
supplied rotary swivel.
Installation
9