Mitel 600 Series User Manual page 70

Mitel 600 Series DECT Phone User Guide
No movement alarm
Escape alarm
64
Delay
Angle
Use Change to switch the no movement alarm on and off.
Alarm in
conversation
Delay
Sensibility
Switch Vibra call off in the Ringer settings (see
you wish to use the no movement alarm.
Use Change to switch the escape alarm on and off.
Alarm in
conversation
Delay
Allows you to set the amount of time the DECT phone
can remain outside the vertical position before a
pre-alarm is triggered (1-75 seconds).
Switch Vibra call off in the Ringer settings (see
"Profiles menu" on page
Mandown alarm.
Select the inclination angle of the DECT phone in which
the alarm will be triggered.
Steep: Approximately 45° from the vertical position.
Medium: Approximately 55° from the vertical position.
Flat: Approximately 65° from the vertical position.
The inclination angle will be detected in each axis of the
DECT phone.
Switch off this feature to prevent alarm activation by
mistake during an active call.
Allows you to set the amount of time the handset can
remain still before a pre-alarm is triggered (1-75
seconds). To prevent unwanted alarms, pressing any
key on the device resets the delay, e.g. if you are
navigating the menu.
Allows you to set the sensitivity (low, medium, high).
This allows you to adapt the sensor to the different
movements (e.g. ways of walking) of the surveillance
personnel:
• Low sensibility means: Slow movements are
enough to reset the delay once again.
• High sensibility means: Only rapid (jolting)
movements will reset the delay.
Switch off this feature to prevent alarm activation by
mistake during an active call.
Allows you to set the amount of time the handset can be
in rapid movement before a pre-alarm is triggered (1-75
seconds).
66) if you wish to use the
"Profiles menu" on page 66) if