LevelOne GSW-4876 User Manual page 72

| Configuring the Switch
C 4
HAPTER
Configuring Security
To select a name from this field, first enter an SNMPv3 user with the
N :
OTE
same Trap Security Engine ID in the SNMPv3 Users Configuration menu
(see "Configuring SNMPv3 Users" on page
W I
EB NTERFACE
To configure SNMP system and trap settings:
Click Advanced Configuration, Security, Switch, SNMP, System.
1.
In the SNMP System Configuration table, set the Mode to Enabled to
2.
enable SNMP service on the switch, specify the SNMP version to use,
change the community access strings if required, and set the engine ID
if SNMP version 3 is used.
In the SNMP Trap Configuration table, enable the Trap Mode to allow
3.
the switch to send SNMP traps. Specify the trap version, trap
community, and IP address of the management station that will receive
trap messages either as an IPv4 or IPv6 address. Select the trap types
to issue, and set the trap inform settings for SNMP v2c or v3 clients.
For SNMP v3 clients, configure the security engine ID and security
name used in v3 trap and inform messages.
Click Save.
4.
– 72 –
74).