Displaying Lacp Port Statistics; Figure 122: Lacp Port Status - LevelOne GSW-4876 User Manual

| Monitoring the Switch
C 5
HAPTER
Displaying Information on LACP
D LACP
ISPLAYING
P S
ORT TATISTICS
LACP – Shows LACP status:
◆
Yes – LACP is enabled and the port link is up.
■
No – LACP is not enabled or the port link is down.
■
Backup – The port could not join the aggregation group but will
■
join if other port leaves. Meanwhile it's LACP status is disabled.
◆ Key – Current operational value of the key for the aggregation port.
Note that only ports with the same key can aggregate together.
◆ Aggr ID – The Aggregation ID assigned to this LAG.
Partner System ID – LAG partner's system ID assigned by the LACP
◆
protocol (i.e., its MAC address).
Partner Port – The partner port connected to this local port.
◆
Partner Priority – The partner port priority used to select a backup
◆
link.
W I
EB NTERFACE
To display LACP status for local ports this switch, click Monitor, LACP, Port
Status.

Figure 122: LACP Port Status

Use the LACP Port Statistics page to display statistics on LACP control
packets crossing on each port.
P
ATH
Monitor, LACP, Port Statistics
P
ARAMETERS
These parameters are displayed:
Port – Port Identifier.
◆
LACP Transmitted – The number of LACP frames sent from each port.
◆
LACP Received – The number of LACP frames received at each port.
◆
Discarded – The number of unknown or illegal LACP frames that have
◆
been discarded at each port.
– 250 –