Showing Ipv4 Sfm Information; Figure 133: Ipv4 Sfm Information - LevelOne GSW-4876 User Manual

Use the IGMP SFM Information page to display IGMP Source-Filtered
S IP 4 SFM
HOWING V
Multicast information including group, filtering mode (include or exclude),
I
NFORMATION
source address, and type (allow or deny).
P
Monitor, IPMC, IGMP Snooping, IPv4 SFM Information
P
These parameters are displayed:
◆
◆
◆
◆
◆
◆
◆
W
To display IGMP Source-Filtered Multicast information, click Monitor, IGMP
Snooping, IGMP SFM Information.

Figure 133: IPv4 SFM Information

ATH
ARAMETERS
VLAN ID – VLAN identifier.
Group – The IP address of a multicast group detected on this interface.
Port – Port identifier.
Mode – The filtering mode maintained per VLAN ID, port number, and
Group Address. It can be either Include or Exclude.
Source Address – IP Address of the source. Currently, the system
limits the total number of IP source addresses for filtering to be 128.
Different source addresses belong to the same group are treated as
single entry.
Type – Indicates the Type. It can be either Allow or Deny.
Hardware Filter/Switch – Indicates whether the data plane destined
to the specific group address from the source IPv4 address can be
handled by the chip or not.
I
EB NTERFACE
– 261 –
| Monitoring the Switch
C 5
HAPTER
Showing IGMP Snooping Information