Panasonic Alarm Protocol - Panasonic WV-SW550 Series Operating Instructions Manual

The settings relating to Panasonic alarm protocol can be configured in this section.
Panasonic alarm protocol notification

[Panasonic alarm protocol]

Select "On" or "Off" to determine whether or not to provide notification by Panasonic alarm protocol according
to the settings for the "Alarm" and "Diag." checkboxes of "Destination of notification" below.
–
When an alarm is detected ("Alarm")
SW559 SW559 SP509 SP509
–
When a notification of the remaining capacity of the SD memory card has been provided ("Diag.")
–
When the SD memory card has become full ("Diag.")
–
When the SD memory card cannot be recognized ("Diag.")
•
Default: Off
Note
•
When "On" is selected, notification of the alarm occurrence will be provided to the registered destination
server addresses in order (to IP address 1 first, to IP address 8 last).
:
SF549 SF549 SF539 SF539
13 Configure the alarm settings [Alarm]
Operating Instructions 127