Device Parameters; Protocols; Enable/Disable Protocols - Mitel NAVIGATOR User And Administrator Manual

Device Parameters

To view the software version and the MAC address:
1. Press (SUPERKEY), and then press >> until ADMIN TOOLS? appears on the display.
2. Press OK. DEVICE PARAMETERS? appears.
3. Press OK. SOFTWARE VERSION appears.
4. View either the software version or the MAC address.
•
To view the software version, press REVIEW (the current software version appears), then
press OK. SOFTWARE VERSION reappears.
•
To view the MAC address, press NEXT (MAC ADDRESS appears), then press REVIEW.
The current MAC address appears. Press OK. MAC ADDRESS reappears.
5. Do one of the following:
•
To return to the main menu, press EXIT.
•
To return to the default display, press
Note: You can also view the MAC address using the Line 1 key (see View the IP and MAC
Addresses on page 3).

Protocols

For information about supported communication and media protocols, access the Web
Configuration Tool online Help (see Access the Web Configuration Tool Online Help on page 3).

Enable/Disable Protocols

To enable/disable protocols using the Web Configuration Tool:
•
Access the tool's Protocols page.
Note: To access the Web Configuration Tool, HTTP must be enabled. If HTTP is disabled
and you need to access the tool, enable HTTP through the Superkey Menu Interface (see
procedure that follows below).
To enable/disable protocols using the Superkey Menu Interface:
1. Press (SUPERKEY), and then press >> until ADMIN TOOLS? appears on the display.
2. Press OK, and then press ▼ until ACCESS PROTOCOLS? appears on the display.
3. Press OK, enter your administrator password, and then press SUBMIT. HTTP <current
status> appears on the display.
4. Do one of the following:
NAVIGATOR - SIP User and Administrator Guide
(SUPERKEY).
41