Setting Up Power Save - Oki ES9455 MFP Software Setup Manual

8.[Administration] Tab Page

Setting up Power Save

You can set Power Save mode for your equipment.
For information on types of Power Save mode and how to enter the mode, see the Quick Start Guide.
1
2
3
4
Item name
1 Auto Clear
2 Auto Power Save
3 Sleep/Auto Shut Off
4 Super Sleep
When the Wireless LAN Module, Bluetooth Module OKI IC Card Reader is installed in this equipment, or when the IPsec
feature is enabled, you cannot change the Super Sleep Mode from [Disable].
If this equipment cannot be found on the network or cannot be connected via network while in Super Sleep, try searching
again.
The equipment may not enter this mode at the set timing depending on its operational status.
The following network settings are required for this equipment to enter the Super Sleep mode.
For the following models, set [Ethernet Speed Duplex Mode] to other than
[AUTO (-1000MB)] or [1000BASE FULL] in the TCP/IP setting.
- ES9170 MFP Series
- ES9455 MFP
P.148 "Setting up TCP/IP"
Select [Disable] for [Enable IPv6] or select [Manual] for [Link Local Address] in the IPv6 setting.
P.152 "Setting up IPv6"
Select [Disable] for [Enable IPX/SPX] in the IPX/SPX setting.
P.153 "Setting up IPX/SPX"
Select [Disable] for [Enable Apple Talk] in the Apple Talk setting.
P.154 "Setting up AppleTalk"
Specify one of the following in [POP3 Network Service].
- [Disable] for [Enable POP3 Client].
- No entry for [POP3 Server Address].
- No entry for [Account Name].
- 0 for [Scan Rate].
P.166 "Setting up POP3 Network Service"
Disable IEEE 802.1X authentication.
For the IEEE 802.1X authentication method under the wired LAN environment, refer to the following chapter in the
MFP Management Guide.
Chapter 2: "SETTING ITEMS (ADMIN) - IEEE 802.1X Authentication Setting"
See the following page for network access settings for your equipment in the Super Sleep mode:
P.174 "Setting up Wake Up Setting"
Select how long your equipment can remain inactive before the touch panel automatically
returns to the default display.
Select how long your equipment can remain inactive before entering Automatic Power Save
mode.
Select how long your equipment can remain inactive before being automatically turned off.
Select whether this equipment enters the Super Sleep mode when the specified period has
elapsed in the Automatic Power Save mode or when the [POWER SAVE] button on the
control panel is pressed.
8 [Administration] Tab Page
Description
[Setup] Item List 145