Navigate To A Waypoint - Lowrance LMS-334c iGPS Installation And Operation Instructions Manual

Create Waypoint by Entering a Position
1. Press , select
WPT
2. Press ↓ to
E
3. Press → to
change the first character, then press → to the next character and re-
peat until the latitude is correct. Press
4. Press ↓ to
change the first character, then press → to the next character and repeat
until the longitude is correct. Press
get back to the main page display.
5. You can also edit your position from the map by selecting
and pressing
M
FROM AP
location and press

Navigate To a Waypoint

You can select any waypoint visible on the Map Page with the cursor,
then use the Navigate to Cursor command (we'll describe how later in
this section.) However, you can avoid scrolling the map to pick your
waypoint if you use the Find Waypoint commands:
1. Press
WPT
nearest waypoint, press ↓ to
. For this example, look by name.
ENT
2. If your waypoint list is a long one, you can spell out the waypoint name
in the
F B N
IND Y
acter, then press → to move the cursor to the next character and repeat
until the name is correct, then press
3. If the list is short, you can jump directly to the
. Use ↑ ↓ to select the waypoint name, press
pressing
ENT
waypoint information screen appears with the
4. To begin navigating to the waypoint, press
M W
Y AYPOINTS
P
NTERED OSITION
|
L ENT
ATITUDE
|
L ENT
ONGITUDE
. Center the cursor crosshairs on the desired
ENT
, which will create a waypoint at that position.
ENT
, select
M W
Y
box to search for it. Press ↑ ↓ to change the first char-
AME
|→ to
S
UBCATEGORY
| |→ to
ENT C
REATE
. Enter the latitude by pressing ↑ ↓ to
ENT
. Enter the longitude by pressing ↑ ↓ to
, then press
ENT
|→ to
AYPOINTS
|
N ENT
EAREST
to jump to the list below.
ENT
114
|↓ to
| .
ENT
.
EXIT
| . To look up the
S ENT
AVED
or to look by name press
F
IND
command selected.
G T
O O
.
ENT
| .
N ENT
EW
repeatedly to
E P
DIT OSITION
box by
I L
N IST
and the
ENT