Navigate To A Waypoint - Lowrance M52 S/GPS Installation And Operation Instructions Manual

7. To clear the search and return to the last page displayed, press
| . (Before you completely exited out of the Search menus, you
EXIT EXIT
could have gone looking for another place.)

Navigate To a Waypoint

You can select any waypoint visible on the Plotter Page with the cursor,
then use the Navigate to Cursor command (we described how to do that
earlier in this section). However, you can avoid scrolling the plotter to
pick your waypoint if you use the Find Waypoint commands:
1. Press . To look up the nearest waypoint, just press
WPT
look by name (and scroll through the entire waypoint list), press ↓ to
|
F B N ENT
IND Y AME
2. If your waypoint list is a long one, you can spell out the waypoint
name in the
F
first character, then press → to move the cursor to the next character
and repeat until the name is correct, then press
below.)
3. If the list is short, you can jump directly to the
. Use ↑ or ↓ to select the waypoint name, press
pressing
ENT
the waypoint information screen appears with the
lected.
4. To begin navigating to the waypoint, press
Plotter screen showing Find Waypoint.
. For this example, look by name.
box to search for it. (Press ↑ or ↓ to change the
B N
IND Y AME
ENT
90
ENT;
to jump to the list
ENT
F I L
IND N IST
command se-
G T
O O
.
or, to
box by
and
ENT