Telephone Base Installation - AT&T CL83143 Abridged User Manual

Getting started

Telephone base installation

Install the telephone base, as shown below.
Plug the large end of the
telephone base power
adapter into a power
outlet not controlled by a
wall switch.
Route the power adapter
cord through this slot.
Raise the antenna.
IMPORTANT INFORMATION
• Use only the power adapter(s) supplied with this product. To order a replacement power adapter,
visit our website at
1 (866) 288-4268
In Canada, dial
For more detailed instructions, refer to the online Complete user's manual at
www.telephones.att.com/manuals
• The power adapters are intended to be correctly oriented in a vertical or floor mount position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling,
under-the-table or cabinet outlet.
Plug the small end of the
telephone base power
adapter into the power
adapter jack on the back
of the telephone base.
www.telephones.att.com
or call
.
.
5
Plug one end of the
telephone line cord into a
telephone jack or a DSL filter.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Route the telephone line
cord through this slot.
Plug the other end of the
telephone line cord into the
telephone jack on the back
of the telephone base.
1 (800) 222-3111
.