Starter Relay Switch/Starter Mag - KYMCO MXU 500 Owner's Manual

19
. STARTER SYSTEM
STARTER RELAY
SWITCH/STARTER MAG
INSPECTION
Turn the ignition switch to "ON".
Squeeze the brake lever or pedal fully.
The coil is normal if the starter relay switch
clicks.
Squeeze and hold the brake lever or pedal
fully then push the starter switch.
The coil is normal if the starter MAG switch
clicks.
If you do not hear the switch click. Inspect
the relay switch and starter MAG using the
procedure below.
GROUND LINE INSPECTION
Disconnect the starter relay switch connector.
Check for continuity between the Green wire
terminal and ground.
There should be continuity.
VOLTAGE INSPECTION
Connect the starter MAG connector.
Turn the ignition switch ON.
Measure the starter MAG Yellow/Red wire
terminal and ground.
If the battery voltage appears only when the
rear brake lever is squeezed fully (or the gear
change switch in neutral) and starter switch is
pushed, the circuit is normal.
19-7
Starter Relay
MXU 500
Starter MAG
Starter Relay
Starter MAG