Hood; Switch - KYMCO UXV450i 2023 Manual

Table of Contents

FEATURES & CONTROLS

HOOD

You can open the hood on your UXV450i to perform

maintenance- related tasks.

To open the hood, unhook the two rubber hood latches

release the six plastic fasteners

fastener to release it and pull if from the hood and the fender. Lift

on the back of the hood to raise it (it is hinged in the front).

and

. Press the center of the plastic

refully

To close the hood, ca

lower it back into place on the

chassis. Hook the rubber hood

latches

Reset the plastic fasteners

and insert them back into the

holes in the hood, the dash,

and the fender extensions. Set

the fastener by pressing the

center pin down so it is flush

with the fastener's button

head.

Ignition Switch

The UXV450i ignition switch is a three-position, key-operated

switch, The key can be removed from the switch when it is in the

OFF position.

OFF: Engine is off.All electrical circuits are off (except accessory

circuit).

ON: The engine can run as the ig- nition is powered. The electri-

cal circuits are on.

START: The starter motor is engaged by turning and holding the

switch in this position. Once released, the switch will return to the

ON position.

Allow thirty seconds between starting attempts to allow the

starting motor to cool. Continuous starting attempts will result in

overheating and damage to the starting motor.

Table of Contents