Drive Belt/Brake Pads Inspection - KYMCO MXU 500 Owner's Manual

3
. INSPECTION/ADJUSTMENT
DRIVE BELT
Remove the left crankcase cover (refer to
the "LEFT CRANKCASE COVER
REMOVAL/INSTALLATION" section in the
chapter 10).
Inspect the drive belt for cracks, scaling,
chipping or excessive wear.
Measure the V-belt width
Service limit (A): 30.8 mm (1.232 in)
Replace the drive belt if out of specification.
Refer to the "DRIVE PULLEY, DRIVE
V-BELT AND DRIVEN PULLEY
REMOVAL/INSPECTION/
INSTALLATION" section in the chapter
10 for removal/installation.
BRAKE PADS INSPECTION
A wear indicator is provided on each brake.
The indicators allows checking of brake
pads wear. Check the position of the
indicator. If the indicator reaches the wear
limit line, to replace the pads.
3-21
Drive Belt
MXU 500
(A)