20. LIGHTS/SWITCHES
Apply three bond: 1215 to the 2WD/4WD
switches and tighten them to the specified
torque.
Torque: 2.2 kgf-m (22 N-m, 16 lbf-ft)
FUEL UNIT
REMOVAL
Remove the fuel tank cover (refer to the
"FRAME COVERS" section in the chapter
2).
Remove the fuel unit connectors.
Remove the four bolts, then remove the fuel
unit from fuel tank.
INSPECTION
Measure the resistance between the
Yellow/White and Blue/White terminals of
the fuel unit connector.
Standard (at 20°C/68°F):
Float at full position
Float at empty position 100 ± 3
INSTALLATION
Fuel unit installation is in the reverse order
of removal.
*
Align the tab on the fuel unit with the
mark on the fuel tank.
20-13
1100 ± 33
Fuel Unit Connectors
MXU 500