Service Information - KYMCO MXU 500 Owner's Manual

16
. BRAKE SYSTEM

SERVICE INFORMATION

GENERAL INSTRUCTIONS
During servicing, keep oil or grease off the brake pads and brake disk.
Drain the brake fluid from the hydraulic brake system before disassembly.
Contaminated brake disk or brake pads reduce stopping power. Clean the contaminated brake
disk with high-performance brake degreaser and replace the brake pads.
Do not use brake fluid for cleaning.
Bleed air from the brake system if the brake system is removed or the brake is soft.
Do not allow any foreign matters entering the brake reservoir when filling the brake reservoir
with brake fluid.
Brake fluid will damage painted, coated surfaces and plastic parts. When working with brake
fluid, use shop towels to cover and protect painted, rubber and plastic parts. Wipe off any splash
of brake fluid with a clean towel. Do not wipe the machine with a towel contaminated by brake
fluid.
Make sure to use recommended brake fluid. Use of other unspecified brake fluids may cause
brake failure.
Inspect the brake operation before riding.
SPECIFICATIONS
Brake disk thickness
Brake disk runout
TORQUE VALUES
Caliper mounting bolt
Brake pad mounting bolt
Brake disc bolt
Bleed valve nut
Brake hose bolt
Master cylinder mounting bolt
Delay valve mounting bolt
Delay valve plug
Item Standard
3.8阡4.2 (0.152阡0.168)
3.2 kgf-m (32 N-m, 25 lbf-ft)
1.8 kgf-m (18 N-m, 13 lbf-ft)
3.5 kgf-m (35 N-m, 25.2 lbf-ft)
0.6 kgf-m (6 N-m, 4.32 lbf-ft)
3.5 kgf-m (35 N-m, 35 lbf-ft)
1.2 kgf-m (12 N-m, 8.6 lbf-ft)
1.2 kgf-m (12 N-m, 8.6 lbf-ft)
5 kgf-m (50 N-m, 36 lbf-ft)
MXU 500
Unit: mm (in)
Service Limit
3 (0.12)
0.3 (0.012)
16-2