Rear Brake Calipers Removal/Inspection/ Installation - KYMCO MXU 500 Owner's Manual

16
. BRAKE SYSTEM
REAR BRAKE CALIPERS
REMOVAL/INSTALLATION
Drain the brake fluid from the hydraulic
brake system (refer to the "REAR BRAKE
FLUID CHANGE/AIR BLEED" section
in this chapter).
Remove the brake fluid hose bolt and two
washers from the caliper.
Remove the brake pads (refer to the
"BRAKE PADS REPLACEMENT"
section in this chapter).
Remove the brake caliper.
INSTALLATION
Install the brake fluid hose with the
attaching bolt and two new sealing washers,
then tighten the bolt to the specified torque.
Torque: 3.5 kgf-m (35 Nm, 25 lbf-ft)
Fill the specified brake fluid and bleed air
from the brake system (refer to the "REAR
BRAKE FLUID CHANGE/AIR BLEED"
section in this chapter).
16-35
Caliper (Brake Lever)
OFF ROAD Type: Caliper (Brake Pedal)
MXU 500