Rear Wheel Removal/Inspection/Installation; Installation - KYMCO MXU 500 Owner's Manual

Hide thumbs Also See for MXU 500:

Table of Contents

REAR WHEEL/AXLE/SHOCK

ABSORBER/SWING ARM

REMOVAL/INSPECTION/

Place the machine on a level place.

Remove four nuts from rear wheel.

Elevate the rear wheels by placing a suitable

stand under the frame.

Support the machine securely so there is

no danger of it falling over.

Remove the rear wheel and wheel hub nut

cap together.

Measure the wheel run out.

Replace wheel or check bearing play if out

of specification

Rim run out limits:

Vertical: 2 mm (0.08 in)

Lateral: 2 mm (0.08 in)

INSTALLATION

When reinstalling a wheel, tighten the

wheel nuts in a crisscross (rather than a

circular) pattern.

Torque: 6.5 kgf-m (65 N-m, 46 lbf-ft)

Be sure the tapered side of the wheel nuts

face the wheel rim.

Chapters

Table of Contents