Sony SRW-5100 Operation Manual page 51

3
Press the [F4] (DETECT ADJUST) button.
The setting display lights up.
4
Change the setting with the cursor R or r button.
You may also use the MULTI CONTROL knob.
5
Press the [F4] (DETECT ADJUST) button.
The data entry window disappears.
Recording stop codes: [F7], [F9]
To record stop codes, press the [F7] (CODE REC) button.
In PLAY, JOG, or similar mode, cue up to the SOM point,
and press the [F9] (EXEC) button. With the point at which
the [F9] (EXEC) button is pressed as the SOM point, after
a preroll, the recording operation starts, and as shown in
the figure below, user bits (value 0) and stop code are
recorded, after which the unit automatically stops. While
the stop code is being recorded, the [F9] (EXEC) button is
displayed in red. After recording is completed, the setting
of the [F7] (CODE REC) button is automatically changed
to OFF.
Note
When the record-protect plug of the cassette is pushed in
or when VTR SETUP menu item 010 "STOP CODE REC
INHIBIT select" is set to "on," pressing the [F9] (EXEC)
button does not record a stop code.
Section to insert time code
Tape
3 frames
1
Press the HOME button.
The HOME menu screen appears.
20 frames 3 frames
2
Press the ALT/[F8] (STOP CODE) buttons.
The STOP CODE menu screen appears.
3
Press the [F7] (CODE REC) button to select "on".
Pressing the button toggles between "on" and "off".
4
Press the [F9] (EXEC) button.
To abandon the operation at any point
Press the STOP button.
To specify the recording start position
Press the [F5] (REC ADJUST) button, to specify how
many seconds before the SOM point the recording of the
stop code should start.
To check the recording
Press the PREROLL button while holding down the SFT
button. The tape prerolls to the SOM point and playback
starts. If the stop code is correctly recorded, regardless of
the settings of the [F2] (DETECT BEEP) button and [F3]
(DETECT STOP) button, a confirmation sound is emitted
for 1 second, and the unit stops in accordance with the
setting of the [F4] (DETECT ADJUST) button. If the unit
does not stop even after passing the point at which the stop
code is recorded, repeat the recording operation.
Note
Checking the recording by pressing the PREROLL button
while holding down the SFT button is only valid in the stop
code menu screen.
Erasing stop codes: [F8], [F9]
To erase a stop code, press the [F8] (CODE ERASE)
button. In stop code detection mode, stop this unit at the
stop code you want to erase, and press the [F9] (EXEC)
button. After prerolling 5 seconds before the stop code
recording point, this unit begins the erasure, and as shown
in the figure below, user bits (value 0) are recorded, after
which the unit automatically stops. After erasure is
completed, the setting of the [F8] (CODE ERASE) button
is automatically changed to OFF.
51
4-2 HOME Menu