Junction Box Installation; Wall Switch Wiring; Install The Light Kit (Optional) - Heatilator GDCH60 Series Owner's Manual

E. Junction Box Installation
If the box will not be wired at the time of appliance instal-
lation, assemble the receptacle and cover to the box and
install on the inside of the appliance.
Remove the junction box assembly from the valve compart-
ment.
If the box is being wired from the OUTSIDE of the appli-
ance:
• Loosen two screws on Romex connector, feed necessary
length of wire through connector and tighten screws.
• Make all necessary wire connections to receptacle and
assemble the receptacle and cover to junction box.
• Attach junction box assembly to outside of appliance with
the two screws provided.
If the box is being wired from the INSIDE of the appliance:
• Pull electrical wires from outside appliance through this
opening into valve compartment.
• Loosen two screws on Romex connector, feed necessary
length of wire through connector and tighten screws.
• Make all necessary wire connections to receptacle and
assemble receptacle and cover to junction box.
• Attach junction box assembly to inside of appliance with
the two screws provided.
F. Wall Switch Wiring
The installer shall supply a UL-listed or in Canada, a CSA-
listed wall switch. This appliance was tested with eighteen
feet of UL listed 18 ga. Type CL2 105° C, two conductor
"thermostat wire". If other wiring materials are used they
shall comply with local codes. In the absence of local codes,
they shall comply with the National Electrical Code ANSI/
NFPA 70-latest edition or Canadian Electrical Code CSA
C22.1.
G. Install the Light Kit (optional)
If not installing the light kit, proceed to Section 11.
• Remove the log/grate assembly by unscrewing the four
screws located on the left and right sides of the assembly.
See Figure 10.4.
Figure 10.4 Remove Log/Grate Assembly
Heatilator • Caliber Multi-Sided Direct Vent • 4002-079 Rev K • 11/07
• Remove the burner assembly by unscrewing the four
screws holding it in place. See Figure 10.5.
Figure 10.5 Remove Burner Assembly
• Remove the sheet metal cover plate by unscrewing the
two screws located in the corners. See Figure 10.6.
Figure 10.6 Remove Sheet Metal Cover Plate
• If you have a "V" series appliance, skip to step 12, just
above Figure 10.10. Open the control access panel to view
the valve compartment. Locate the two cover plates. See
Figure 10.7. Using a short phillips screwdriver, remove the
two screws on the cover plate. Repeat for other side.
Figure 10.7 Cover Plates
41