•
Remove four screws holding outer cover to appliance
back. See Figure 7.5. Remove outer cover (be sure to
remove the insulation as well).
Figure 7.5
Outer Cover - Remove Four Screws
•
Remove four screws holding inner cover plate to appliance
back. See Figure 7.6. Remove inner cover.
Figure 7.6
Inner Cover - Remove Four Screws
•
Place inner collar on appliance back and replace four
screws to hold this collar in place. See Figure 7.7.
Figure 7.7
Attach Inner Collar
28
Heatilator • Caliber Multi-Sided Direct Vent • 4002-079 Rev K • 11/07
•
Place outer collar on rear of appliance and replace four
screws to hold collar in place. See Figure 7.8. Make sure
insulation is attached to the collar base!
Figure 7.8 Attach Outer Collar
•
Locate the cover plate removed in the fi rst step. Place
plate around rear vented collars and replace four screws
to hold plate in place. See Figure 7.9.
Figure 7.9
Attach Cover Plate
•
Place inner cover plate on appliance top and replace
four screws to hold inner cover plate in place. See
Figure 7.10.
Figure 7.10 Attach Inner Cover Plate