Heatilator GDCH60 Series Owner's Manual page 42

• Take the light base assembly and position it into the
rectangular hole. Using the screws removed in the
previous step, attach the light base to the valve plate.
See Figure 10.8. Repeat for the other side.
Figure 10.8 Light Base Assembly
• Remove one green wire and screw from the power box
and attach that wire and screw to the fi rebox support hole
located in the bottom right-hand corner of the fi rebox
support.
• Place the fl ange on the power box into the formed tab in
the bottom pan.
• Peel the plastic off the Velcro and press it onto the bottom
pan.
• Plug the light base assembly connector into the power
box. See Figure 10.9.
• With the wall switch in the "OFF" position, plug the power
box cord into the junction box on the switched outlet
side. For intermittent pilot ignition appliances, plug the
transformer into the outlet of the power box.
• With the wall switch in the "OFF" position, plug the power
box cord into the junction box on the switched outlet
side.
Figure 10.9 Power Box
42 Heatilator • Caliber Multi-Sided Direct Vent • 4002-079 Rev K • 11/07
• Remove the halogen bulbs from the packaging and screw
them into the light base. See Figure 10.10. Once the
bulbs are in place, clean the surface of the bulbs with a
soft cloth and Isopropyl rubbing alcohol to remove any
fi ngerprints.
Figure 10.10 Light Base
• Remove the glass panel from its packaging and place it
on the glass supports. Place the colored side down. See
Figure 10.11.
Figure 10.11 Glass Panel
• Replace the burner assembly using the four screws
removed. Place the burner on the brackets so that there
are ports in front of the pilot hood. See Figure 10.12.
Figure 10.12 Burner Assembly