Planet FGSW-2840 User Manual page 238

Use the interface type
number command to enter
Interface
this mode from Global
Configuration
Configuration mode.
Mode
Use the vlan database
VLAN
command to enter this mode
Configuration
from Global Configuration
Mode
mode.
The user is automatically in User EXEC Mode after the connection between the PC and the Managed
Switch is established by a telnet connection.
Each command mode has its own set of specific commands. To configure some commands, you
should access the corresponding command mode firstly.

Global Configuration Mode:
In this mode, global commands are provided, such as the Spanning Tree, Schedule
Mode and so on.

Interface Configuration Mode:
In this mode, users can configure one or several ports, different ports corresponds to
different commands.
a).
b).
c).
d).
e).

Vlan Configuration Mode:
In this mode, users can create a VLAN and add a specified port to the VLAN.
Some commands are global, that means they can be performed in all modes:
show: display all information of Managed Switch, for example: statistic information, port
history: Display the commands
Table 6-1: CLI Command Modes
Interface Ethernet: Configure parameters for an Ethernet port, such as Duplex-mode,
flow control status.
Interface range Ethernet: Configure parameters for several Ethernet ports.
Interface link-aggregation: Configure parameters for a link-aggregation, such as
broadcast storm.
Interface range link-aggregation: Configure parameters for multi-trunks.
Interface vlan: Configure parameters for the vlan-port.
information, VLAN information.
history.
User's Manual of FGSW-2840 / FGSW-4840S
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
Enter exit command to return to Global
FGSW-4840S
Configuration mode.
(config-if)#
A port number must be specified in the
interface command.
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
FGSW-4840S
(config-vlan)# Enter the exit command to return to
Global configuration mode.
238