Test Print - Oki MC860 Maintenance Manual

Oki Data CONFIDENTIAL

5.10.3.5 Test print

This self-diagnostic menu is used to print the test pattern contained in the PU. Other test
patterns are contained in the controller
This test print cannot be used to check the print quality.
To diagnose the abnormal image, refer to item 7.
1. Enter the self-diagnostic mode (Level 1) and press the (2) key or (8) key until
[TEST PRINT] is displayed in the top of the screen. Then, press the (6) key. (The
(2) key increments the test item and (8) key decrements the test item.)
2. The setting items that are applicable to the test print only are displayed in
the lower column of display window. Press the (2) key or the (8) key until the
corresponding item is displayed. Then, press the (6) key. (The (2) key increments
the item and (8) key decrements the item.) (When the setting value for each item
is not required [Default setting], advance to item 2.)
3. Keep pressing the (2) key or the (8) key, and press the (6) key at the item that
is set in item 2. The setup item is displayed in the upper column, and the setting
value is displayed in the lower column of the display window. Pressing the (2)
key increments the setting value. Pressing the (8) key decrements the setting
value. (The setting value that is displayed last is applied.) Pressing the (4) key
determines the setting value, and the screen returns to item 2.) Repeat item 3
as required.
43967002TH Rev.1
Display Setup value
PRINT EXECUTE –
TEST PATTERN 0
TEST CASSETTE TRAY1
TRAY2
MFP
PAGE 0000
COLOR ON
OFF
DUPLEX 2 PAGES STACK
OFF
1PAGES STACK
MONO SPEED LOW
HIGH
• is the initial value. The set item is valid in this test mode only.
(It is not saved in EEPROM.)
Note!
PAGE setting ........................ Pressing the (2) key or the (8) key shifts the digit. When the (
) key is pressed, the setting value increments. Pressing the # key
decrements the setting value. If test print is executed with the print
number setting "0000", print will continue infinitely. Be careful not to
set "0000".
COLOR setting ........................ When the (6) key is pressed while set to ON, the following contents
are displayed on the panel screen.
Print setting of each color............ Pressing the (2) key or the (8) key shifts the value.
Pressing the ( ) key or the (#) key enables operator to switch
between ON and OFF setting.
Pressing the (4) key returns the screen to operator panel display.
5. Maintenance Menu
Function
Pressing the (4) key starts printing/Pressing
the (#) key ends printing (in page unit).
0 White paper print
1 to 7 Refer to next page. (Pattern print)
8 to 15 White paper print
Select the paper feed source.
If TRAY2 is not installed, TRAY2 is not displayed.
Setting the number of test prints.
Selecting color or monochrome print.
* ON is specified, ON/OFF setting for each color
appears.
Duplex print is executed with two sheets stack.
Duplex print OFF select
Duplex print is executed with single sheet stack.
Selecting monochrome print speed.
LOW: 30ppm
HIGH: 34ppm(A4),33ppm(Letter)
245 /