Installing The Switch; Pre-Installation Considerations; Rack-Mounting The Switch; Powering On The Switch - Linksys Etherfast User Manual

Installing the Switch

Pre-Installation Considerations

Fast Ethernet Considerations
If you will be using the Switch for Fast Ethernet (100Mbps) or Gigabit
(1000Mbps) applications, you must observe this guideline:
The maximum UTP cabling length using Category 5 cable is 328 feet (100m).
Full-Duplex Considerations
As previously mentioned, the Switch provides full-duplex support for its RJ-
45 ports. Full-duplex operation allows data to be sent and received simultane-
ously, doubling a port's potential data throughput.
If you will be using the Switch in full-duplex mode, the maximum UTP cable
length using Category 5e (or better) cable is 328 feet (100 meters).
Positioning the Switch
Before you choose a location for the Switch, observe the following guide-
lines:
• Keep cabling away from sources of electrical noise, power lines, and
fluorescent lighting fixtures.
• Position the Switch away from water and moisture sources.
• To ensure adequate air flow around the Switch, be sure to provide a
minimum of one inch (25mm) clearance.
• Do not stack free-standing Switches more than four units high.
6
EtherFast Series EtherFast
®

Rack-Mounting the Switch

The EtherFast
free-standing unit, or installed in any standard 19-inch rack.
Use the following instructions to rack-mount the Switch:
Before you begin, disconnect all cables from the Switch.
1. Place the Switch right side up, with the front panel facing you.
2. Position a mounting bracket over the screw holes on one side of the
3. Secure the mounting bracket by inserting three screws into the screw
4. Repeat steps 2 and 3 to install the other mounting bracket on the opposite
5. Insert the Switch into the 19-inch rack and secure it with suitable

Powering on the Switch

To power on the Switch, simply connect the AC power cord to the back of the
Switch, and then plug the power cord into an electrical outlet. The Switch
will boot up within approximately 30 seconds.

Uplinking the Switch

Any of the 26 ports on the EtherFast
Switch can act as an uplink port, allowing you to uplink to other switches or
hubs using a standard Ethernet connection. UTP Category 5e (or better)
cable is recommended when using the Gigabit ports.
To uplink the switch, connect one end of a network cable into the Switch,
then connect the other end of the cable into the desired network device's
uplink port.
Managed 24-Port with Dual Gigabit Switch
®
® Managed 24-Port with Dual Gigabit Switch can be used as a
Switch.
holes. Use a screwdriver to tighten the screws, ensuring that they are
fastened firmly in place.
side of the Switch.
screws (not provided). Ensure that the ventilation holes are not obstructed.
The rack-mount installation is complete.
You can now re-connect the cables to the Switch.
® Managed 24-Port with Dual Gigabit
7