Linksys Etherfast User Manual page 12

Network Configuration
The Network Configuration menu allows you to set the Switch's IP address,
configure the IP parameters, or enable the on-board Web management.
• IP Configuration* - Sets the bootup option or configure the Switch's IP
parameters.
• IP Connectivity Test (Ping) - Tests IP connectivity to a specified device.
• HTTP Configuration - Allows the admin to enable or disable the Web
administration.
* This menu does not appear if the Switch is set to multilayer mode. In this
case, you need to configure an IP interface for each VLAN that needs to con-
nect to any device outside of its own VLAN group.
Select OK to return to the previous panel.
18
EtherFast Series EtherFast
®
Select Apply to make changes. Select OK to return to the previous panel.
Select Cancel to cancel any changes.
Managed 24-Port with Dual Gigabit Switch
®
IP Configuration
The IP Configuration menu allows you to configure the IP parameters.
(Only displayed in Layer 2 mode)
• Interface Type - Indicates IP over Ethernet.
• IP Address - IP address of the Switch you are managing. The system
supports SNMP over UDP/IP transport protocol. In this environment, all
systems on the Internet, such as network interconnection devices, must
have an IP address.
• Subnet Mask - Subnet mask of the Switch. This mask identifies the host
address bits used for routing to specific subnets.
• Gateway IP - Gateway used to pass trap messages from the system to
the management station. Note: The gateway must be defined (when oper-
ating at Layer 2) if the management station is located in a different IP
segment.
• IP State - Specifics whether IP functionality is enabled via manual con-
figuration (default setting), or set by Boot Protocol (BOOTP).
19