Serial Port Configuration
The Serial Port Configuration screen allows you to access the communication
parameters for the Switch's serial port.
• Baud Rate - The rate at which data is sent between devices. Default is
19200. Options are 9600, 19200, and 38400 baud.
• Data Bits - Sets the data bits of the RS-232 port. Options are 7 and 8.
• Stop Bits - Sets the stop bits of the RS-232 port. Options are 1 and 2.
• Parity - Sets the parity of the RS-232 port. Default is None. Options are
none, odd, and even.
• Time-Out - If no input is received from the attached device after this
interval, the current session is automatically closed. Default is 10 minutes.
The range is 0 to 100 minutes, where 0 indicates disabled.
• Auto Refresh - Sets the interval before a console session will auto refresh
the console information, such as Spanning Tree Information, Port
Configuration, Port Statistics, and RMON Statistics. Default is 1 second.
The range is 0, or 5 to 255 seconds, where 0 indicates disabled.
Select Apply to make changes. Select OK to return to the previous panel.
Select Cancel to cancel any changes.
22
EtherFast
Series
EtherFast
®
SNMP Configuration
The SNMP Configuration screen displays parameters for the Simple Network
Management Protocol (SNMP).
• Send Authentication Fail Traps - Issue a trap message to specified IP
• SNMP Communities - Assigns SNMP access based on specified strings.
• IP Trap Managers - Specifies management stations that will receive
Select OK to return to the previous panel.
Managed 24-Port with Dual Gigabit Switch
®
trap managers whenever authentication of an SNMP request fails. Default
is enabled.
authentication failure messages or other trap messages from the Switch.
23