Linksys Etherfast User Manual page 31

Managed 24-port with dual gigabit switch instant etherfast series

Hide thumbs Also See for Etherfast:

Table of Contents

Enlarged version

Add Static ARP Entry

The Add Static ARP Entry screen is used to add a static ARP entry.

• IP Address - IP address statically mapped to a physical MAC

address.

• MAC Address - MAC address statically mapped to the correspon-

ding IP address.

• Interface - The index number of the IP interface that will use

this static ARP entry. (Port "0" refers to the CPU.)

Select OK to return to the previous panel. Select Cancel to cancel any

changes.

EtherFast

Series

EtherFast

Select Apply to make changes. Select OK to return to the previous panel.

Select Prev Page to view the previous page. Select Next Page to view the

next page. To display a specific page, set the page number in the Page field

and then press Apply. Select Add to add a routing entry.

Managed 24-Port with Dual Gigabit Switch

Static Route Table

The Static Route Table screen is used to configure a static route.

• Destination Network - A destination network, subnet, or host.

• Destination Mask - The subnet mask that specifies the bits to match.

A routing entry will be used for a packet if the bits in the address set by

the destination mask match the destination network.

• VLAN - The VLAN within which the gateway or destination address

resides.

• Next Hop - The IP address of the router at the next hop.

• Type - The IP route type for the destination network.

Direct - A directly connected subnetwork

Indirect - A remote IP subnetwork or host address

Myself - A switch IP address on a specific IP subnetwork

Bcast - A subnetwork broadcast address

Mcast - An IP multicast address

Invalid - An illegal IP address to be filtered

Table of Contents

Etherfast ef24g2m