Linksys Etherfast User Manual page 22

Add Static Address Entry
The Add Static Address Entry screen allows you to add static
addresses for unicasting.
• Address - The MAC address of a host device attached to this
Switch.
• Port - The switch port the host device is attached to.
Select OK to confirm the changes. Select Cancel to cancel any changes.
38
EtherFast Series EtherFast
®
Select Apply to make changes. Select OK to return to the previous panel.
Select Prev Page to view the previous page. Select Next Page to view the
next page. To display a specific page, set the page number in the Page field
and then press Apply.
Managed 24-Port with Dual Gigabit Switch
®
Static Multicast Address Configuration
The Static Multicast Address Table can be used to assign a destination
MAC address (and the corresponding ports) to the VLAN group used for a
specific multicast service. Static multicast addresses are never aged out,
and traffic with these addresses can only be forwarded to ports specified
in this table.
• VLAN - The VLAN corresponding to this multicast service.
• Address - The destination MAC address for a multicast service.
• Port - The ports to which this multicast traffic can be forwarded. Read
the numbers vertically; they range from 1-26. For each port number,
there are two choices:
If the letter "M" is present, it indicates that the VLAN has access to
messages transmitted by that particular port.
If there is no letter "M," then there is no access to messages trans
mitted by that particular port.
39