Linksys Etherfast User Manual page 39

• 1024-1518 Byte Frames - The total number of frames (including bad
packets) received and transmitted where the number of octets fall within
the specified range (excluding framing bits, but including FCS octets).
• 1519-1536 Byte Frames - The total number of frames (including bad
packets) received and transmitted where the number of octets fall within
the specified range (excluding framing bits, but including FCS octets).
Select Apply to make changes. Select Refresh to refresh the statistics. Select
OK to return to the previous panel. Select Reset to reset a specific statistic.
Select Reset All to reset the all statistics. Select Prev Port to view the previ-
ous port. Select Next Port to view the next port. To display a specific port,
set the port number in the Port field and then press Apply.
Layer 2 Address Table
The Unicast Address Table contains the MAC addresses associated with each
port (that is, the source port associated with the address).
• Address - The MAC address of a node seen on this Switch.
• Port - The port whose address table includes this MAC address.
Select Apply to make changes. Select OK to return to the previous panel.
Select Prev Page to view the previous page. Select Next Page to view the
next page. To display a specific page, set the page number in the Page field
and then press Apply.
72
EtherFast Series EtherFast
®
Bridge Menu
The Bridge Menu is used to display settings for the Spanning Tree Algorithm,
as well as the global bridge settings for GMRP (GARP Multicast Registration
Protocol) and GVRP (GARP VLAN Registration Protocol), traffic classes
priority threshold, and address aging time.
• Spanning Tree Bridge Information - Displays a full list of STA values
• Spanning Tree Port Information - Displays a list of STA values used for
Select OK to return to the previous panel.
Managed 24-Port with Dual Gigabit Switch
®
used for the bridge.
each port, including status, designated cost, designated bridge, and desig-
nated port.
73